agricultural bearings Angular contact ball bearing

Angular contact ball bearing is a bearing, it can support radial and axial loads. Able to work at higher speeds. The contact angle, the higher the axial load carrying capacity. High-precision and high-speed bearings usually take the contact angle of 15 degrees. In the axial force, the contact angle will increase. crossed roller bearings‍ Angular contact ball bearings can support radial and axial loads. Able to work at higher speeds. The contact angle, the higher the axial load carrying capacity. High-precision and high-speed bearings usually take the contact angle of 15 degrees.

In the axial force, the contact angle will increase. Single row angular contact ball bearings can withstand axial load in one direction, while the radial load, will cause additional axial force. And the only limit axial displacement in one direction shaft or housing. If paired installation, so that one pair of bearing outer ring relative to that wide side face of wide and narrow side facing the narrow end. This can avoid additional axial force, and the shaft or thin section bearing‍ housing to limit axial clearance within the range in both directions.

Angular contact ball bearing raceway for its inner and outer rings relative displacement on the horizontal axis, so it can support radial load and axial load - combined load (single row angular contact ball bearings can withstand axial load in one direction, So often adopted installed in pairs).

Cage made ​​of brass, synthetic resins, etc., depending on the bearing forms, and application conditions.

Angular contact ball bearings: 7000C-type (α = 15 °), 7000AC type (α = 25 °) and 7000B (α = 40 °) of several types. This kind of bearing outer ring of locking in the general inner and outer rings can not be separated, can withstand radial and axial joint load and axial load in one direction. Axial load capacity from Slewing drives‍ the contact angle, the contact angle is large, the ability to withstand high axial loads. This kind of bearing can limit the axial displacement in one direction shaft or housing.